1-8. To properly prepare the user’s input for processing, you as I/O control clerk must have a certain amount of information available, such as computer run sheet, how to make up control or SCL statements,    and any special  output  requirements the job may call for. This information can be found in the 1. run book 2. job manual 3. task folder 4. master run manual 1-9. A run sheet to be used by the computer operator should contain which of the following  information? 1. Breakpoints 2. Partition  numbers 3. Recovery  procedures 4. List of required inputs 1-10. If a job terminates before going to a normal EOJ, you as the I/O control clerk may be required to collect which of the following data/information? 1. Output data and memory dump  only 2. Input data and SCL statements  only 3. Input data,    output  data, and  memory  dump 4. Output  data,  console printout,  and  SCL statements 1-11. 1-12. During  the  SUADPS  daily update  for  supply,  problems reading  the  current  master read file (MRF) on disk drive 241 are encountered. The job terminates prematurely, leaving eight jobs to be run. The computer  operator  calls  on you as the I/O control clerk to help in the recovery process. You can be expected to perform all except which of the following tasks? 1 . 2. 3. 4. As Provide  the  operator with the input parameters  and/or  SCL statements  to  recover the job Remove  the  defective disk pack from drive 241 and forward it to the technicians to be checked out See to it that the remaining  jobs  are rescheduled  once  the master file is recreated, and  notify the user Provide  the  operator with the file identification   number needed to recover the MRF file an I/O control clerk, to determine that a job ran successfully and that all processing  steps  were properly  carried  out,  you should review what document? 1. The pass down log 2. The computer run sheet 3. The  confirmation  report 4. The  computer  console printout 2